View Single Post
  #3 (permalink)  
Old November 8th, 2006, 09:25 PM
poja poja is offline
Authorized User
 
Join Date: Oct 2006
Location: , , Singapore.
Posts: 12
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via MSN to poja
Default

hi,
there is no such information.. the only information they have provided is a flow chart on how the device works.

it says after receiving the command it Uses AT commands to send it to the AT+++ (Software Configuration) if not it takes pin 15 low (Hardware Configuration).

i guess i have to call the AT command of the software into the program.But since i am not familiar with VB.NET i am not too sure how!well there are 2 AT commands.

Enter AT Command Mode: 41 54 2B 2B 2B 0D(this is the command).
Exit AT Command Mode: CC 41 54 4F 0D (this is the command).

but i m not too sure Wheather this is the one that needs to be called