When I open a project that was created on one PC on a different PC the IDE does not recognise basic functions like trim and left etc.

I am able to get the project working by going through the entire app and specifying VBA.Trim, etc.

I assume this is because of a dual meaning of the VBA function names.

Is there anything I can do to make the app recognise the VBA functions straight away as VB does when they are created.

Any assistance would be greatly appreciated.


======================================
They say, best men are molded out of faults,
And, for the most, become much more the better
For being a little bad.
======================================

__________________
======================================
"They say, best men are molded out of faults,
And, for the most, become much more the better
For being a little bad."
--Shakespeare
======================================

Can anyone help with this?

======================================
They say, best men are molded out of faults,
And, for the most, become much more the better
For being a little bad.
======================================

It appears that the problem had risen from missing references that where unrelated to the VBA dll's.

I had some nokia dll's referenced that I had not used in the app, when I installed the nokia sdk all was well.

I guess I could similarely have removed the reference to the nokia dlls.

======================================
They say, best men are molded out of faults,
And, for the most, become much more the better
For being a little bad.
======================================